Working Principle Of Sand Cylinder

Mar 16, 2025 Leave a message

The working principle of sand cylinder mainly includes the following steps:

Filtration process: When the pool water passes through the filter, tiny dirt is captured and filtered out by the sand bed. The filtered clean water returns to the pool through the pipe from the bottom of the filter through the control switch. This whole set of procedures is continuous and automatic, providing a complete circulation process for the filter and pipeline system.

Backwashing process: As the use time increases, the dirt accumulated in the sand cylinder will hinder the water flow, resulting in a decrease in the filtering effect. At this time, the filter needs to be cleaned. The specific operation is to turn the control switch to the "BACKWASH" ​​position, the water flow will flow in the opposite direction, directly reach the bottom of the filter cavity, and then backwash through the sand layer, flushing the dirt and residue out of the sewage outlet. After each backwash, the control switch should be turned to the "RINSE" position, the water pump should be turned on for 0.5 to 1 minute and then turned off, and then turned to the "FILTER" position to restart normal filtration.

Filtering effect: The sand tank can effectively remove suspended particles, impurities and microorganisms in the pool water through the physical barrier effect of the filter sand, keeping the water clean. The particle size and filling density of the filter sand have an important influence on the filtering effect. Generally, the smaller the particle size and the denser the filling, the better the filtering effect, but it will also increase the resistance of the water flow.

Maintenance: Regular backwashing and inspection of the sand tank is the key to keeping it in good working condition.